Welcome to YTUnity

One free SpiderTaz Network account works across every network site.

Making a Splined Shaft Then Doing it again Because of not Having The whole Picture of the System

bcbloc02 Video 3 days ago

Description

In this video I fabricate a new shaft to replace an obsolete Shaft That was failed from excessive torque load combined with a poor factory Design. That poor factory design led me to miss the fact they had mounted bearings over the cut splines rather than giving them a proper shoulder and thus gave the shaft all kinds of stress concentrations. Doing it differently to try to make it better would have required making at least 5 other parts and was cost prohibitive so back like it was it goes!

Featured creators

Creators on the SpiderTaz Network

Become a creator →