Description
HIKMICRO Pocket2 thermal camera:
https://go.skill-builder.uk/hikmicro-pocket2
This video is a paid promotion for HIKMICRO. HIKMICRO had no say in what we found or what we said about it.
Roger takes the HIKMICRO Pocket2 thermal camera round an old house to see what it can actually find, using its SuperScene modes along the way. Two dead underfloor heating circuits, heat pouring out of an uninsulated boiler room, a hot doorbell transformer, cold bridging on a solid wall, dislodged loft insulation, and a damp corner in the cellar that led us straight to a blocked drain outside.
KEY TAKEAWAYS
• A thermal camera reads surface temperature and nothing else. It can't see through a wall or a floor, so it tells you where to look and you still have to work out why.
• Underfloor heating circuits that have sat idle all summer can air lock, and a thermal camera shows a dead circuit in seconds without lifting a single floorboard.
• Uninsulated pipework, temperature relief valves and secondary tappings on a hot water cylinder lose a surprising amount of heat, and they're some of the cheapest things in a house to insulate.
• In a consumer unit you're comparing like with like. If one circuit breaker is running hotter than its neighbours under similar load, that's the one to get an electrician to look at.
• Glass is about the worst surface you can point a thermal camera at, because much of what comes back is reflection. Adjusting the emissivity setting helps you get a truer reading.
• SuperScene's Water Leak mode flags suspect areas rather than diagnosing them. It led us to a damp corner in the cellar, but the actual cause was only found by going outside and looking.
CHAPTERS
0:00 Intro
0:13 The HIKMICRO Pocket2
1:38 SuperScene modes explained
1:53 Finding dead underfloor heating circuits
3:45 Heat loss in the boiler room
5:24 Pipe-in-screed underfloor heating
6:24 Cold walls and old damp
7:38 Checking the consumer unit
10:05 Checking a new car charger
10:36 Why glass fools a thermal camera
10:59 Solar gain through a roof lantern
12:08 Finding studs and joists
12:50 Cold bridging on a solid wall
14:54 Heat through the ceiling
15:58 Checking loft insulation
17:33 Water Leak mode finds damp
19:29 Tracking down the cause
20:33 The biggest limitation
#ThermalImaging #HIKMICRO #UnderfloorHeating #HeatLoss #SkillBuilder
==================================
👇 SUPPORT SB - BECOME A MEMBER
https://www.youtube.com/channel/UC9GdB6vG6m6cDAwrTAWXgyg/join
📪 JOIN OUR NEWSLETTER
https://skill-builder.uk/signup
🛒 SEE OUR FAVOURITES ON AMAZON
https://www.amazon.co.uk/shop/skillbuilder
🎧 LISTEN TO OUR PODCAST
https://blubrry.com/skillbuilder/subscribe
🎬 OUR VIDEO LIBRARY
https://www.youtube.com/@SkillBuilder/videos
🔗 SEE EVERYTHING SB ON LINKTREE
https://linktr.ee/skillbuilder
https://www.facebook.com/skillbuilderchannel
https://www.tiktok.com/@skillbuilder
https://www.instagram.com/skill_builder
(As an Amazon Associate, we earn from qualifying purchases)
==================================
OUR FAVOURITE CHARITIES
👷 BAND OF BUILDERS
https://bandofbuilders.org
⛯ THE LIGHTHOUSE CHARITY
https://lighthousecharity.org
💧 CHARITY WATER
https://www.charitywater.org
