Welcome to YTUnity

One free SpiderTaz Network account works across every network site.

Featured creators

Creators on the SpiderTaz Network

Become a creator →

Don't Replace Your Slate Roof Until You Watch This

Skill Builder Podcast 4 days ago

Description

Roof valley leaking in wind-driven rain, even after three different roofers have had a go at it?

Paul's 1920s house was re-slated with fibre cement slates about 20 years ago, and the same valley has leaked ever since, with around £12,000 spent so far trying to fix it.

Roger thinks the valley was built wrong from the start. The battens run straight into the valley instead of sitting slightly above it, so there's no way to fit a tilting fillet or welted edge to stop wind-driven rain, and there are no counter battens to let condensation drain away under the slates.

Working from Paul's photos of the stripped roof, Roger goes through the slate fixings, the breather membranes, the batten detail and what he'd do to put it right, then hands it over to the roofers watching.


KEY TAKEAWAYS

• Fibre cement slates are smooth and uniform, so they sit tight together and can draw moisture up between them by capillary action, where natural riven slate leaves room for air to move underneath.

• Counter battens are worth fitting with fibre cement slates and a breather membrane, because they give condensation coming through the membrane a clear channel to run down the roof instead of sitting trapped behind the battens.

• A valley needs a tilting fillet or a welted edge on both sides to stop wind driven rain getting under the slates, and that only works if the battens sit slightly higher than the valley lining.

• On this roof the battens run straight into the valley without being cut to the angle, so some don't even reach a rafter, and fitting a fillet or GRP valley would leave the slates cocked up along the edge.

• Before the slates go back on, running a hose over the stripped valley should show where water is getting through the membrane, and a small patch repair may be all it needs.

• Roger's suggested fix is to take the valley out, set it lower into the rafters and run the battens over it, so a GRP valley overlaps the battens on both sides and the slates still run through at the right height.


WATCH NEXT

https://youtu.be/2rwH3EdV_rE

https://youtu.be/vKkTKHpwnj8


CHAPTERS

00:00 Paul's leaking valley
00:54 £12,000 and still leaking
01:22 Fibre cement slates and rivets
01:52 Why artificial slates hold moisture
02:28 Breather membranes: Tyvek and Cromar Vent 3
03:22 Why you need counter battens
05:02 Is that what's causing the leak?
05:10 Battens running into the valley
06:14 The tilting fillet
07:37 Three roofers, nobody spotted it
07:50 Could you drop the valley?
08:31 Battens that miss the rafters
09:02 Trapped condensation under the battens
10:08 The hose pipe test
10:22 Roger's fix
11:02 Lead work and chimney
11:37 Over to you, roofers

Roofers, do you agree with Roger, or have you seen this one before? Let us know in the comments. Got a problem of your own? Send it in!

#Roofing #RoofLeak #RoofValley #FibreCementSlates #SkillBuilder

====================

👇 SUPPORT SB - BECOME A MEMBER https://www.youtube.com/channel/UC9GdB6vG6m6cDAwrTAWXgyg/join

📪 JOIN OUR NEWSLETTER https://skill-builder.uk/signup

🛒 SEE OUR FAVOURITES ON AMAZON https://www.amazon.co.uk/shop/skillbuilder

🎧 LISTEN TO OUR PODCAST https://blubrry.com/skillbuilder/subscribe

🎬 OUR VIDEO LIBRARY https://www.youtube.com/@SkillBuilder/videos

🔗 SEE EVERYTHING SB ON LINKTREE https://linktr.ee/skillbuilder

🤝 WORK WITH US https://skill-builder.uk/media

facebook.com/skillbuilderchannel

tiktok.com/@skillbuilder

instagram.com/skill_builder

(As an Amazon Associate, we earn from qualifying purchases)

====================

OUR FAVOURITE CHARITIES

👷 BAND OF BUILDERS https://bandofbuilders.org

💡 THE LIGHTHOUSE CHARITY https://lighthousecharity.org

💧 CHARITY WATER https://www.charitywater.org