Welcome to YTUnity

One free SpiderTaz Network account works across every network site.

How to Normalize Audio Levels in Shotcut Videos

Max Dalton Guide Yesterday

Description

In this video I'll show you how to normalize audio levels in Shotcut videos. When you combine clips that were recorded on different devices or at different distances from the mic, some end up much louder than others, and normalizing brings them all to the same loudness.

Timestamps:
Introduction: 0:00
Normalize Each Clip: 0:36
Normalize a Whole Track: 1:56
Conclusion: 2:39

Support this channel by becoming a member: https://www.youtube.com/channel/UCBbDWMccTJCL0WmbMHNLZIw/join

Video Transcript:
The first method uses the "Normalize: Two Pass" filter, which analyzes a whole clip and then applies one fixed volume change to hit the loudness you choose. This gives the most natural result, but it works on one clip at a time.

Step 1. Click the clip you want to normalize on the timeline to select it. In this example, I'll click the second clip, which is much quieter than the first.

Step 2. Click "Filters" in the toolbar at the top of the window, click the "+" button, type "normalize" in the search box, and then click "Normalize: Two Pass." The filter is added to the clip.

Step 3. Set the "Target Loudness." Around -14 LUFS is a good choice for videos you're posting online.

Step 4. Click "Analyze." Shotcut runs a job to measure the clip, and when it finishes, the filter shows the detected loudness and the gain it's applying.

Step 5. Repeat these steps for every other clip you want to match, using the same target loudness each time. If you change a clip or its filters later, click "Analyze" again so the numbers stay accurate.

The second method uses the "Normalize: One Pass" filter. It can be added to a whole track at once and keeps adjusting the volume as the video plays, which is useful when the volume changes a lot within a single clip.

Step 1. Click the track header on the left side of the timeline, such as "A1," to select the whole track.

Step 2. Click "Filters," click the "+" button, type "normalize" in the search box, and then click "Normalize: One Pass." The filter is added to the track.

Step 3. Set the "Target Loudness" to the level you want, and then click "Play" under the preview to listen. Every clip on that track now plays at a more consistent level.

If you hear the volume pumping up and down with the one pass filter, try increasing its "Window" setting so it reacts more slowly.

Featured creators

Creators on the SpiderTaz Network

Become a creator →