Description
In this video I use ChatGPT to diagnose my air compressor tripping its circuit breaker after about five seconds, then check and clean the centrifugal switch.
I give ChatGPT the symptoms and work through its suggestions. The compressor started working again before filming, so I did the checks anyway. A clamp-on ammeter showed it drawing 8 amps on a 12 amp breaker. I safely discharged the start and run capacitors and measured them, and the run capacitor read 29 microfarads on a 30 microfarad rating. I then pulled the fan and end bell off and found a corroded centrifugal switch mechanism. After a clean, I checked the contacts for continuity and put it all back together. It still runs, and I think the intermittent fault points to that switch.
I also cover how AI helped with a flashing Victron inverter and a metal detector charger. I also show where it got the sensor wrong on a motorcycle neutral switch problem, and why parts diagrams are so useful.
Chat excerpts:
THE COMPRESSOR:
Q: I got the fan and the bell end off and the centrifigal mechanism does look corroded. Also the shaft came out a bit in the process, can I just tap it back in until it stops?
A: Yes, I can see the centrifugal mechanism clearly now, and there's enough corrosion there that I'd definitely investigate it. The spring-loaded mechanism on the shaft operates the stationary electrical contacts mounted in the end bell below it.
On the shaft movement: don't tap the shaft/rotor back in until it stops. The rotor isn't normally located axially by simply hammering it home. You've most likely pulled the rotor partly out of the stator because the rear bearing remained in the end bell as you removed it. That's common during disassembly.
Instead, when reassembling:
Gently slide the rotor back into its normal position by hand, supporting its weight so the rotor doesn't scrape against the stator windings.
The bearings and end bells ultimately establish the rotor's axial position.
Fit the end bell over the bearing and bring everything together progressively.
Use the end-bell bolts to secure the assembly only once everything is properly seated; don't use the bolts to force a badly misaligned bearing/end bell together.
Once assembled, turn the shaft by hand. It should rotate freely without scraping or binding.
That centrifugal switch deserves attention
The shaft mechanism in your photo looks quite rusty, particularly around the springs, weights/pivoting parts and sliding collar. It needs to move freely.
With everything unplugged as it is now, operate the mechanism gently by hand. The weights should move outward and the collar should move axially, then spring positively back to its resting position when released. It shouldn't stick anywhere.
The stationary contact assembly in the end bell is also visible at the bottom of your photo. I'd check that the contacts open and close positively when its actuator is moved. You can verify that with the Hantek in continuity/resistance mode.
Given your original symptoms—trip after ~5 seconds, followed later by the compressor mysteriously working normally again—a corroded/sticking centrifugal mechanism has become a very credible suspect. If it occasionally fails to disengage the start circuit after the motor reaches speed, the start winding/capacitor can remain energised and the overload can trip.
For outboard and boat repair information, check out my guide: https://guide.dangarmarine.com.au/
If you're enjoying this channel, please consider becoming a channel member at https://www.youtube.com/channel/UCBsXuIe0nBO3Bi2JmtVk1ZQ/join or making a donation at https://www.paypal.me/dangarstu
T-shirts and other merchandise: https://dangar-marine-shop.fourthwall.com/
Tools and parts I use in these videos: https://www.amazon.com/shop/dangarmarine (as an Amazon Associate I earn from qualifying purchases)
Dangar Marine is proudly sponsored by MarineEngine.com, which supplies spare parts for many brands of outboard motors: https://www.marineengine.com/
Music: https://soundcloud.com/dangarstu
