Description
In today's video, we are taking the DIY Voi rental scooter wheelie plate to the next level! After the iron bar bent in the first test, I went back to the workshop to reinforce the setup with an extra iron bar, new screws, steel wires, and a heavy-duty ratchet strap.
Watch until the end as Tobias stops by on his KuKirin G2 alongside a Joyor T10, showing off some mind-blowing new scooter wheelie tricks!
📍 Timestamps:
0:00 - Introduction & Teaser
0:25 - Back in the Workshop: Straightening the Bent Bar
1:05 - First Street Test & The Zip Ties Snap!
1:45 - Reinforcing with Steel Wires & Ratchet Strap
2:30 - Fine-Tuning: Leveling the Wheelie Plate
3:15 - Tobias & Joyor T10 Join the Session
4:05 - Crazy Wheelie Tricks & Street Cruising
4:35 - Final Thoughts & Outro
🔧 What I modified in this video:
Straightened and reinforced the bent iron support bar.
Replaced plastic zip ties with steel wire and a ratchet strap.
Leveled out the wheelie plate using a custom wedge.
Tested parallel alignment for perfect stability during wheelies.
If you enjoy DIY electric scooter projects, modifications, and street testing, don't forget to LIKE & SUBSCRIBE for more crazy builds!
Disclaimer: The KuKirin link above is an affiliate link, meaning I earn a small commission if you make a purchase through it, at no extra cost to you.
Discount Link: https://www.kugooescooters.com/?ref=qpzvcddu
#ElectricScooter #VoiScooter #ScooterWheelie #DIY #KuKirinG2 #ScooterMod #WheeliePlate #TechDIY
