Description
Got it, here it is in English:
*Why your machine is not sucking water properly:*
This is usually not a motor problem. It is mostly an *air lock or blockage* in the suction line.
*Fix it step by step:*
*1. Prime the Pump*
- Turn OFF the machine
- Put the suction pipe fully inside the bucket of water
- Press and hold the gun trigger WITHOUT turning on the machine for 30 seconds
- Let water flow out of the gun by itself
- When water starts coming, then turn ON the machine
*2. Check Inlet Filter*
- Where the pipe connects to the machine, there is a small mesh filter
- If dust or mud is stuck there, suction will stop
- Remove it, clean it with a brush and put it back
*3. Check Suction Pipe*
- Check for any cut, leak or loose joint. If air enters, it will not suck water
- Keep the pipe short, 2 to 3 meters max
- Keep the bucket slightly higher than the machine, not too low
*4. Check Foot Valve / Strainer*
- The brass strainer at the end of the pipe sometimes gets jammed
- Clean it and make sure it is fully under water
*5. Last Trick*
- Pour one mug of water directly into the inlet, then run the machine for 5 seconds. This removes trapped air.
*Important:* Do not run the machine without water for more than 1 minute. It will damage the pump seal.
Tell me one thing - are you taking water from a *bucket / tank or direct tap?*