RCLifeOn

3D Printing a Jetboat

Short | 2 months ago

I Didn't Think It Was Going To Be This BAD!

Short | 4 months ago

3D printing things that shouldn't be 3D printed

Short | 4 months ago

3D Prints Are Everywhere!

Short | 4 months ago

I Built an Amphibious Car That Works

Video | 5 months ago

This is how I built an amphibious car using foam as boyancy and an efoil motor attached to a Z-axis gantry to activate water-mode or land-mode. Thank you PCBWay for sponsoring the video! https://www.pcbway.com/?from=rclifeon Contact: rclifeon2014@gmail.com

Ice Airboat Built With Drone Motors

Video | 6 months ago

I built a 20kW electric airboat powered by high-output drone motors and a lithium battery pack. The frame is made from standard lumber and plywood, painted blue, and fitted with skis from two old snow racers so it can glide on ice. In this video, I show the...

This $20 Snow Blower Cost Me $1000

Short | 8 months ago

Turning a $20 Gas Snow Blower Electric

Video | 8 months ago

I bought a $20 gas snow blower on Facebook Marketplace and converted it to electric power. In this video, I remove the gas engine and replace it with two electric motors, redesign the drive system, and integrate a battery setup to see if a full-size snow bl...

3D Printed Hydrofoil Bike First Testing

Guide | 10 months ago

Brilliant: https://brilliant.org/RCLifeOn/ How to modify a servo tester to work with a hall sensor: https://www.youtube.com/watch?v=cceUTv6tAaA Music: Closer - STRLGHT Finding Zion - Aiyo IGGY - Heyson

3D Scanning Just Got Interesting Again!

Video | 10 months ago

In today's video we're going to put 3D scanning in 2025 to the test! How good is the Creality Raptor with the Prusa XL? No affiliate scanner link: https://store.creality.com/products/cr-scan-raptor-3d-scanner Sponsor PCBWAY: https://www.pcbway.com/?from=rcl...

460 Kilometers LATER - Does It Still Work?

Short | 11 months ago

Egg Incubator Build

Short | 11 months ago