Edge Precision

Indicating Hole In Stock

Video | 3 months ago

How I prep stock to turn OD concentric to ID hole.

Weigh it down

Video | 4 months ago

Put Weights On Part To Damp Out Chatter ON Lathe Part.

Steady Rest For Totoda Bridge Mill

Video | 1 years ago

Building as simple steady rest I could think of for a setup on the Toyoda Bridge Mill.

Chip Conveyor Rebuild

Video | 1 years ago

Finally got to fixing the chip conveyor for the Mazak Intergrex. This is the video of what I did.

Edge Finding A Part With Overhangs

Video | 1 years ago

How I find the center of the part using a dial indicator in the spindle.

Special Measuring Gauge

Video | 1 years ago

I Needed a special measuring gauge to measure part that could not be measured with a standard mic.

Luer Connection For My Air Gun

Video | 1 years ago

A project I did in my garage to replaced a missing air gun. I use this to blow out shavings in small holes.

Nuestro habitación en México.

Video | 1 years ago

A quick video showing our room/living quarters. In our building project in Mexico. (Un video rápido que muestra habitación/vivienda en nuestro proyecto de construcción en México.)

Special Studs To Fix A Problem

Video | 1 years ago

Boring the spindle housing

Video | 2 years ago

Boring and threading the spindle housing for the spindle cartridge. Showing some unusual machining operations on the Mazak Integrex.

Special Wrench

Video | 2 years ago

I needed a special wrench for the Spindle's Housing Nut. To be able to tighten it. So I made one. I also explain what this spindle is being used for in this video.

Spindle Shaft For Offset Spindle

Video | 2 years ago

The spindle shaft of a special parallel spindle attachment for the Mazak Integrex. To mill into a slot/cavity ends of a large titanium part.