doublereno

Lichtenberg Wood Burning

Video | 2 years ago

This video is for demo purposes only! Lichtenberg Wood Burning can be dangerous and cause serious injury or even death. Do no attempt! Doublereno Website http://www.fractalburn.com Facebook at https://www.facebook.com/FractalBurn/ Instagram at https://www.i...

Replace Dewalt DW705 Handle

Guide | 2 years ago

I had to replace the clamshell handle on my Dewalt DW705 12” Miter saw. There are several types of these saws, each one may have a different handle. My saw is a DW705 Tupe 4a. I will show you how to check which type DW705 saw you have so you order the corre...

Cut Oversized Pieces on Atomstack Laser

Guide | 3 years ago

I will show you how to cut out a piece of leather that is wider than the laser bed on my Atomstack laser. This is referred to as Tiling. I am also now an affiliate for Angelus paints and dyes. The best out there in my opinion with great prices buying direct...

Leather Fire Helmet Shield

Video | 3 years ago

Designed and made a leather helmet shield for a Phenix TL-2 leather firefighter helmet. Designed the fire shield in Lightburn and cut it out on my Atomstack laser. Used Angelus dyes and paints and stitched it all together using saddle stitching. I am also n...

Saddle Stitching for Dummies

Video | 3 years ago

I show you an easy way to do saddle stitching. I break down every step of creating a saddle stitch. I go over every step including the back stitch in a way that you can do your own saddle stitching! Here is a link to products I used from Amazon: (Affiliate)...

Beekeepers Wallet

Short | 3 years ago

Custom made leather pouch for holding Beekeepers tools while working beehives.

Cut Leather With A Dremel Tool

Video | 3 years ago

I had to trim the end off of a leather beekeepers pouch that I had vacuum formed. It wasn’t flat so I could not use a knife like you normally would. I used my Dremel tool with a mini saw blade and it worked great. Check out the finished product on my instag...

Leather Hat Patch on Laser

Short | 3 years ago

My new Leatherworks logo cut out on my custom dyed leather for a hat patch. #angelusdirect WJOXOIWS56IOL0YX

Leather Card Wallet No. 5

Video | 3 years ago

I designed a 5 card wallet in Lightburn and cut it out on my Atomstack laser. I dye the leather, burnish it, lace by hand with saddle stiches. I show the entire process. Here is a link to products I used from Amazon: (Affiliate) Atomstack S10 Pro Laser http...

Design CNC Router Clamps In Vcarve

Guide | 3 years ago

I design wooden CNC clamps for my Onefinity Woodworker CNC Router using the Vectric’s Vcarve software. I show you how to design the wooden clamps and to create tool paths so you can cut the clamps out on your CNC Router. Spetools https://spetools.com/?ref=q...

Surface a CNC Router Table

Short | 3 years ago

Surface the Onefinity Spoilboard

Video | 3 years ago

I cut my oversized Spoilboard. I surfaced my Onefinity CNC Spoilboard using a 1 1/8” surfacing bit. I was able to flatten the Spoilboard bigger than the normal cut limits of the Onefinity Woodworker CNC. I use Vectric VCarve Pro to design a Spoil board surf...